Submit a request

Artec Studio 15.1 HD mode - Hardware Requirements

Introduced in Artec Studio 15.1, the HD mode (High Definition mode) is a completely new algorithm that greatly enhances the quality of Artec Eva and Artec Leo scans.

Performed on raw Eva or Leo scans, "HD reconstruction" is a complex process that requires a lot of computing power and memory.
In order for the algorithm to perform optimally, an adequate GPU is required: a modern NVIDIA graphics card with at least 2GB of VRAM (for Artec Eva) or at least 4GB of VRAM (for Artec Leo).
For optimal calculation times, an NVIDIA card with a CUDA compute capability of at least 6.1 and  8+ GB of VRAM is highly recommended.

If the graphics card does not meet the minimum requirements (or an outdated graphics driver is installed), the HD reconstruction algorithm will be executed on the CPU instead of the GPU.
This will cause the algorithm to perform many times slower, potentially taking multiple hours to complete even the simplest calculation.

The table below features general hardware recommendations for optimal HD reconstruction speeds. The GPU section is structured into three groups, based on the HD reconstruction speed/performance of each GPU:
Slow: 1.5 - 2.5 FPS
Normal: 2.5 - 4.5 FPS
Fast: 4.5 FPS and higher
(The FPS reconstruction rate is a measure of how many raw frames the algorithm can process per second, and can be calculated by dividing the number of frames by the time elapsed during HD reconstruction).

(!) HD reconstruction works on Nvidia GeForce RTX 30 Series cards only in Artec Studio version and newer.


(!) There is a known issue with the following CPUs and Artec Leo -> the issue will be addressed in the future release of Artec Studio

11th generation Intel Core i5, i7, i9 - 11XXX
Mobile 10th generation i3, i5, i7- 10XXGX




In case you experience any issues with your Artec 3D scanner or require technical assistance with your device or Artec Studio, in the first instance please contact your local Artec dealer/distributor directly. You can also contact the Artec Support Team by clicking on "Submit a request" button on the bottom right part of the screen or by emailing


Was this article helpful?
1 out of 1 found this helpful