Submit a request
Follow

Supported sensors (Artec Studio 9, 10, 11, 12)

Note, that the sensors, mentioned in the table below, are supported only in the Ultimate edition of Artec Studio 10, 11 and 12. The differences between the Ultimate and the Professional edition are highlighted here.

Sensor model

AS 9

AS 10

AS 11

AS 12

MS Kinect V1 + + + +
MS Kinect V2   + + +
ASUS XTion + + + +
PrimeSense Carmine + + + +
Intel RealSense F200 (IVCAM)   + + +
Intel RealSense R200 (DS4)   + + +
Intel RealSense SR300     + +
XYZprinting 3D scanner   + + +

 

Intel RealSense D415 and D435

At the moment, D415 and D435 sensor are not supported in Artec Studio Ultimate and we do not plan to implement this support in our software in 2018.

 

3D Systems Sense

3D Systems Sense is not officially supported in Artec Studio, therefore, if you run into any issues using this equipment with the Artec Studio, we might not be able to provide the necessary technical assistance to have these issues resolved.

  • The new generation Sense scanner uses Intel RealSense SR300 sensor which works in Artec Studio 11/12 Ultimate. However, since the sensor is positioned at a 90-degree angle, you will have to hold it "flat" while scanning, in order to have proper visualization on screen.
  • The prior generation Sense is based on the PrimeSense Carmine sensor. This should also work with Artec Studio 9, 10, 11 and 12.

 

Several sensors, connected to one PC

You can create a bundle of several sensors, however, it depends on the type of sensors. More information can be found in this article.

 

We are here to help! If you have any questions or issues, please do not hesitate to contact our team by emailing support@artec-group.com or by clicking on "Ask Support" button on the upper part of the screen. We will always be happy to assist you and will get back to you as soon as we can.